VARGA Puller Tool for Motor Mount Replacement

Special auxiliary tool for removing the saw blade mount from the motor shaft when replacing the motor. The tool enables safe and damage free removal of the mount during maintenance or repair of the machine. The puller tool is used during motor replacement to detach the mount from the motor shaft and reinstall it on the new motor.

• Suitable for: VA 1, VA 2, VA 10, VA 21-7, VA 21-15, VA 31-15
• Dimensions: 120 x 15 x 15 mm (4.72 x 0.59 x 0.59 in)
• Weight: 283 g (0.624 lbs)

• 1x Puller Body
• 3x Screws

Manufacturer:
Varga System GmbH, Hainkämpe 5, 28832 Achim, Germany
Email: info@varga-system.com

Warning Notes:
When removing the saw blade mount, components may suddenly loosen. This may cause a risk of injury due to crushing or sharp edges. There is also a risk of injury when working on the saw blade. Before starting any work, ensure that the machine is switched off and completely disconnected from the power supply.

Safety Instructions:
The puller tool may only be used by qualified personnel. Before use, ensure that the tool and the fastening screws are not damaged. During disassembly, wear appropriate personal protective equipment, especially cut resistant protective gloves and safety glasses. Use the tool only for its intended purpose to remove the mount.

Intended Use:
The puller tool is intended exclusively for removing the saw blade mount from the motor shaft when replacing the motor on compatible precision table saws.