VARGA Carbide Cutter VA 2, 24 Teeth

The original Varga carbide cutter is a spare part for the Varga edge milling unit VA 2. With a diameter of 120 mm, a 20 mm bore, and a cutting width of 1.8 mm, it ensures precise and clean cuts. Equipped with 24 durable teeth, it delivers efficient material removal and long service life.

• Suitable for: VA 2
• Diameter: ⌀ 120 mm × 1.8 mm (4.72 x 0.07 in)
• Speed: 15,000 rpm
• Amount of Teeth: 24

Manufacturer:
Varga System GmbH, Hainkämpe 5, 28832 Achim, Germany
Email: info@varga-system.com

Warning Notes:
The saw blade is extremely sharp and can cause cuts. Flying chips can cause eye injuries. Wear safety goggles. Overloading the saw blade can lead to breakage and flying parts. Improper installation can cause safety risks.

Safety Instructions:
Use protective gloves when assembling or disassembling the saw blade. Wear personal protective equipment such as goggles and hearing protection during operation. Only cut materials within the recommended thickness and hardness. Check the saw blade regularly for damage and replace it if necessary. Carry out assembly only according to the instructions in the manual.

Intended Use:
The product is designed for precise cutting of plastics, aluminum, brass and other non-ferrous metals in Varga table saws.