Diamant Gravers 3,17x110mm 120°

Diamond Graver
Non-rotating tool
Diamond angle: 120°
Surface marking only
3,17 x 110,0 mm

Diamond Graver non-rotating tool intended for scratch engraving of trophy brass and aluminum. Suitable for surface marking only .
Diamond angle: 120°
Shank Diameter: 3,17 mm Length: 110,0 mm

Manufacturer:
Innograv GmbH, Leinenkamp 9, 27299 Langwedel, Germany
E-mail: info@innograv.com

Warning Notes:
Attention: Sharp edges! Risk of injury in case of direct contact. Do not use on unsuitable materials such as stainless steel. Do not continue to use damaged tools.

Safety Instructions:
Use only for scratch engravings on suitable materials such as brass and aluminum. Store the tool in a protective case to prevent damage. Use only in designated machines. Use a local exhaust system in the area of dust and particle development.

Intended Use:
The product is designed for precise scratch engraving on brass and aluminum surfaces.

Prices are only available upon verified registration on this website