Go to homepage
Go to homepage

1 Flute Router-Mill 5,00 x 50mm / 5,0mm

1 Flute Router-Mill 5,00 x 50mm / 5,0mm
  • 1 Flute Router-Mill
  • For cutting plastics
  • Spiral O-flute
  • Polished flute
  • Tip width 5,0 mm
  • 5,0 x 50 mm
  • Length of cut 16 mm
1 Flute Router-Milll. Right hand cut, right hand helix, spiral O-flute. For cutting soft plastics, hard plastics, and acrylic. Maximum material removal with outstanding finish. Polished flute helps prevent chip welding.
Shank Diameter 5,0 mm
Length: 50 mm
Cutting edge diameter (tip width): 5,0 mm
Length of cut: 16,0 mm
Suitable for: ACR (acrylic) / FLX (soft plastics - flexible engraving stock)

Manufacturer:
Innograv GmbH, Leinenkamp 9, 27299 Langwedel, Germany
E-mail: info@innograv.com

Warning Notes:
Attention: Sharp edges! Risk of injury in case of direct contact. Particulate matter can be harmful to health when inhaled.

Safety Instructions:
Use cutters only with suitable machines and settings. Check regularly for wear or tear and replace if there is visible damage. Use a local exhaust system in the area of dust generation.

Intended Use:
The product is designed for precise engraving and cutting of engraving materials.

Minimum order quantity 1
Maximum order quantity 10000
Product number: 62R1U050516