End Mill - Two Flutes 3,0x37mm / 2,5mm

2 Flutes End Mill
Spiral O-flute
Tip width 2,5 mm
3,00 x 37 mm

2 Flute End Milll. Right hand cut, right hand helix, spiral O-flute. For cutting soft plastics, hard plastics, and acrylic. Maximum material removal with outstanding finish.
Shank Diameter 2,5 mm
Length: 37 mm
Cutting edge diameter (tip width): 3,0 mm
Suitable for: ACR (acrylic) / FLX (soft plastics - flexible engraving stock) / BAL (soft metals - brass, aluminum)

Manufacturer:
Innograv GmbH, Leinenkamp 9, 27299 Langwedel, Germany
E-mail: info@innograv.com

Warning Notes:
Attention: Sharp edges! Risk of injury in case of direct contact.

Safety Instructions:
Use cutters only with suitable machines and settings. Check regularly for wear or tear and replace if there is visible damage. Use a local exhaust system in the area of dust generation.

Intended Use:
The product is designed for precise engraving and cutting of engraving materials.

Prices are only available upon verified registration on this website