1 Flute Router-Mill 3,00 x 38mm / 2,0mm

1 Flute Router-Mill
For cutting aluminum & soft metals
Spiral O-flute
Polished flute
Tip width 2,0 mm
3,0 x 38 mm
Length of cut 5 mm

1 Flute Router-Milll. Right hand cut, right hand helix, spiral O-flute. For rapid cuts in aluminum while maintaining a superior finish. Polished flute helps prevent chip welding.
Shank Diameter 3,0 mm
Length: 38 mm
Cutting edge diameter (tip width): 2,0 mm
Length of cut: 5,0 mm
Suitable for: BAL (soft metals - brass, aluminum)

Manufacturer:
Innograv GmbH, Leinenkamp 9, 27299 Langwedel, Germany
E-mail: info@innograv.com

Warning Notes:
Attention: Sharp edges! Risk of injury in case of direct contact. Particulate matter can be harmful to health when inhaled.

Safety Instructions:
Use cutters only with suitable machines and settings. Check regularly for wear or tear and replace if there is visible damage. Use a local exhaust system in the area of dust generation.

Intended Use:
The product is designed for precise engraving and cutting of engraving materials.

Prices are only available upon verified registration on this website